C-COM Satellite iNetVu Anleitung zur Fehlerbehebung PDF herunterladen (Seite 20)

iNetVu Troubleshooting Guide

C-COM Satellite Systems Inc.

Page 20 of 88

• Upon hitting “Calibrate AZ” or “Calibrate PL”, the software will automatically switch to the controls

screen to commence the calibration. On the bottom right hand side a message under the status

section, will display “AZ/PL Calibration” as shown below.

• We must wait for this message to change to “System Idle” and only “System Idle” which is the

official indication that the process is completed. Afterwards we can proceed to the next axis or

move on if both axis are complete.

• You have successfully replaced the controller.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 87 88

Keine Kommentare

C-COM Satellite iNetVu Anleitung zur Fehlerbehebung Seite 20